JGAurora A5 - Custom Marlin Firmware 1.1.8C Heatbed temperature is not riged adjusted

I bought a used JGAurora A% and had some problems with the hotend heating first. After i changed the port in the firmware 1.1.8.c that worked right again. But now I have problems with the temperature of the heatbed. It starts with 72 degrees even ti has only 27 degrees on the bed. If I add temperature to 90 degrees it goes up to 41 degrees, but not more.

Comments

  • Stephen ToddStephen Todd Posts: 281🌟 Super Member 🌟
    As replied to in your other post, your Makerbase MKS Gen_L controller board has failed - buy another one from amazon or official makerbase store on aliexpress - they are $20 or less

    Unfortunately it is a common fault on these boards - happened to me - both the hot end and bed temperatures went wrong at the same time - I simply replaced the board, and everything was instantly perfect again - and the old board is now an arduino mega for use with other electronic projects
  • Samuel PinchesSamuel Pinches Posts: 2,628Administrator
Sign In or Register to comment.