using Octoprint with JGmaker Magic

y2kats65y2kats65 Posts: 9Member
What are the axis printer values (x, Y, Z, E) I should use to setup the Octoprint?  thanks.

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,715Administrator
    edited May 18
    Hi, welcome @y2kats65
    I'm not sure what you mean by printer values? Do you mean print volume?  x = 220mm, y = 220mm, z = 250mm
    Post edited by Samuel Pinches on
  • sirhcwolfsirhcwolf Posts: 20Member
    I'm with @Samuel Pinches , what values?
    Thanked by 1Samuel Pinches
  • y2kats65y2kats65 Posts: 9Member
    Sorry for the late response.  I am referring to the individual axis speed/feedrate rate setting.  The default settings are:
    X and Y 6000 mm/min
    Z 200 mm/min
    E 300 mm/min
    invert control off
    Are these the correct settings for Magic?
  • Samuel PinchesSamuel Pinches Posts: 2,715Administrator
    edited June 18
    If you want to find out the current printer motion settings on any marlin printer, you can generally send Gcode command "M503 S1", and the printer will write the current settings out to the console log in Octoprint:

    Post edited by Samuel Pinches on
Sign In or Register to comment.