weird things on prints... stringing?? maybe

FunInAlaskaFunInAlaska Posts: 18Member
OK, I was printing a batch of the nose clips that keep fabric masks from fogging up glasses for my wife and I. 
And on many of them I have these weird little needle like things sticking off at an angle. It doesn't look like stringing because it is not horizontal it is at about a 45 degree angle. and they are a lot thicker than I am used to strings being.
I have used 3 different filaments with the same gcode and had very similar results with each.
What is this and what causes it and how do I stop it to clean up prints like this?

Comments

Sign In or Register to comment.