JGMaker is having a CLEARANCE sale on the commercial-grade Z-603S -- at a BONKERS $399. If you're in the USA, and want a ready-to-go full steel frame printer... run, don't walk! ⏩ JGAURORA Z603S CLEARANCE ⏪ Only 4 units left!

jgaurora a5s lcd

Hi, my screen sensor is broken. Can you tell me if I can replace this screen with another motherboard not me? For example, install 2004 lcd or similar.

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,916Administrator
    edited April 17
    Welcome @rattlhead -- the motherboard and LCD are proprietary, but the bare 320x240 LCD and touch panel should be a fairly generic part that you might be able to find on aliexpress with a bit of digging. There might be a part number printed on the LCD backside.
    You could try contact JGMaker and ask them as well.
    Otherwise you would probably need to do a fair bit of work to replace both the motherboard and LCD as a combo. Another option would be to add a raspberry PI and attached screen to connect and control the printer over a USB cable instead.
    Thanked by 1rattlhead
    Post edited by Samuel Pinches on
  • rattlheadrattlhead Posts: 2Member
    Sorry, I'm using google translator. I cannot start printing even from a computer. At the beginning of printing, the printer unloads and loads plastic and requires confirmation of the action, but my screen is broken and I cannot confirm this. Tell me how to remove this function from the firmware.
  • Samuel PinchesSamuel Pinches Posts: 2,916Administrator
    @rattlhead If you are using my community firmware, you should be able to add the following line at the start of your gcode, to tell the marlin firmware to ignore the filament run out sensor:
    M412 S0
    (can also add a line with M500 if you want to save this change to eeprom)
  • Samuel PinchesSamuel Pinches Posts: 2,916Administrator
    If that doesn't work, then please upload a photo of the message you see.
Sign In or Register to comment.