problems with Y and Z axes

Dr_ThingDr_Thing Posts: 2Member
Hello. My JGaurora A3S is not recognizing the Y and Z axes. It simply does not move them and does not return to the home. I would like to know if anyone can help me to solve this problem. thank you.
Post edited by Samuel Pinches on

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,695Administrator
    Most likely it is a loose connection on the X axis endstop. You can test the function of all your endstops using pronterface, and sending the command M119.
    Thanked by 1Dr_Thing
  • Dr_ThingDr_Thing Posts: 2Member
    Thanks

  • Samuel PinchesSamuel Pinches Posts: 2,695Administrator
    send command M119, and see what state is reported for each endstop. Then, while holding down each endstop, send the command again to see that the changed state is correctly detected.
  • Samuel PinchesSamuel Pinches Posts: 2,695Administrator
    You're welcome- let us know how you go :smile: . By the way, there is a "thanks" button in each post to mark helpful posts.
    Thanked by 1Dr_Thing
Sign In or Register to comment.