My A5 stopped in the middle of a print, no problems found.

DIYglennDIYglenn Posts: 31🌟 Super Member 🌟
I had one print fail halfway with no warning. 
The only special thing I can think of is that I had it connected to Repetier Host with a USB cable before printing, and unplugged and printed from a USB stick. 
Everything was smooth until it just stopped with the nozzle on the print. 

I re-sliced the (test-) model and power cycled the printer this time before printing again. 
Did three prints afterwards without any issue. 

I don’t like this, I’m afraid that the cables for the bed or similar have been worn/damaged and now could stop the prints at random times. 

Anyone seen even this Issue?
Sign In or Register to comment.