Heating problem...

elbico

I have a problem with my printer, the nozzle and the bed arent heating... I have standards numbers with the nozzle, but the bed is stuck with strange numbers: 132/50 Can't figure it out... Solutions please ?

Prokktor

Hmm strange.
I could imagine the software deactivates heating because the bed is already way to hot (it thinks^^)

Can you use an ohm meter and measure the termistor under your heat bed at room temperature?
(Either on the Mainboard (pinout in the wiki) or you disassemble the heat bed (Da Hais Video) and measure at the connector)

Samuel Pinches

The advice from @Prokktor is good. I also recommend having a read of the steps on the wiki A5 FAQ page: https://jgaurorawiki.com/a5/faq#problemheating-problems-with-nozzle-or-heated-bed