NEW Budget 3D Printer: JGMaker Magic - here's the best deals at the moment:
- Gearbest: Flash sale for $189
- Banggood Store: Take off $20 with coupon bd5cc5
- Amazon USA - $30 instant discount coupon
[6th Nov 18] The NEW recently released JGAurora A5S is already for sale under $400! Print quality is better than A5 out of the box.
Click here to check out this deal!

Marlin Software für den A5X klappt nicht richtig

gabrielsfallgabrielsfall Member Posts: 1
edited December 2018 in JGAurora A5X
Hallo,
ich habe heute die geänderte Marlinsoftware für den A5X hier aus dem Forum geladen und gemäß Anleitung installiert. Jetzt hab ich das Problem, das die Endstopschalter wohl nicht richtig erkannt werden. Der Drucker macht beim Homing seltsame Geräusche und das Heizbett bleibt Mittig stehen. Ich habe folgende Einstellungen geändert:
- #define EEPROM_SETTINGS // Enable for M500 and M501 commands (Additional Features)
- #define GRID_MAX_POINTS_X 4    // Don't use more than 7 points per axis, implementation limited. (Mesh)
Hat vielleicht einer ne Idee?
Lieben Gruß
Mario

Hello,
I have today downloaded the modified Marlinsoftware for the A5X here from the forum and installed according to instructions. Now I have the problem that the endswitch probably not be recognized correctly. The printer makes strange noises when homing and the heating bed stays in the middle. I changed the following settings:
- #define EEPROM_SETTINGS // Enable for M500 and M501 commands (Additional Features)
- #define GRID_MAX_POINTS_X 4 // Do not use more than 7 points per axis, implementation limited. (Mesh)
Maybe an idea?
Greets
Mario

Post edited by gabrielsfall on

Comments

Sign In or Register to comment.