JGAURORA JGMaker Magic Promotion


NEW Budget 3D Printer: JGMaker Magic
The best deal at the moment is from Gearbest, who are running a flash sale for just $179!
Amazon USA also is offering an $30 instant discount coupon on the JGAurora Magic - a great option for those who want it even faster!

JGAURORA A5S Deals


[6th Jun 19] The LATEST JGAurora A5S is already for sale under $400 - use coupon GBA5S11 for a further $15 off!
Print quality is better than A5 out of the box, and it only takes 10 minutes to assemble.
Click here to check out this deal!

Baby steps option is not working

Hello, colleagies.
I have installed a marlin 1.1.8c firmware in printer board and 3.03 firmware (community build) in LCD module. The menu "baby steps" is awailable now, but when i try to adjust the 1st layer height use up and down arrows, nothings happend. Z motors are not moving.
What should be done in firmware for activation this functionality?
Thanks in advance. 

Comments

  • Samuel PinchesSamuel Pinches Posts: 1,754Administrator
    - check that you have done the m500 / m502 steps in the firmware installation
    - the steps are very very small - you may need many steps to notice a change, and the change is not instantaneous - it is queued in the buffer, so it can take some time before you observe a change.

    Otherwise, I'm not sure - you could try sending the babystepping commands from pronterface and see if they are working there.
Sign In or Register to comment.