NEW Budget 3D Printer: JGMaker Magic - here's the best deals at the moment:
- Gearbest: Flash sale for $189
- Banggood Store: Take off $20 with coupon bd5cc5
- Amazon USA - $30 instant discount coupon
[6th Nov 18] The NEW recently released JGAurora A5S is already for sale under $400! Print quality is better than A5 out of the box.
Click here to check out this deal!

"#power down" and too much"LCD ID:9341"

Hi 

Have a nice day!
I have jgaurora a5s 3d printer 
The touch screen turns itself off randomly during printing and then turns on again

I observed with pronterface. I found the following errors

It gives LCD ID error continiously and LCD Screen is twinkling at the same time.

How can I solve this problem? Thanks!

Comments

  • Samuel PinchesSamuel Pinches Administrator Posts: 1,618
    edited March 6
    @sametarayici- firstly, welcome! :smiley:

    Sounds like it could be a fault with the motherboard? I suggest contact JGAurora ( support@jgew3d.com )

    Post edited by Samuel Pinches on
  • sametarayicisametarayici Member Posts: 4
    ı think so Thank you Samuel  ı will contact jgaurora support 
  • sametarayicisametarayici Member Posts: 4
    I contacted company.
    Jgaurora will send new motherboard
  • Richy_TRichy_T 🌟 Super Member 🌟 Posts: 77
    Did you try reseating the LCD connector? Sometimes things shake loose during shipping.
  • sametarayicisametarayici Member Posts: 4
    Jgaurora sent new motherboard .
    I resaeting LCD connector and but the problem continues
  • Samuel PinchesSamuel Pinches Administrator Posts: 1,618
    🤦‍♂️
Sign In or Register to comment.