Touchscreen not working

Hello, I know this is going to be difficult to trouble shoot but thought I would reach out for help. I made a mistake by using a wire brush to clean off my nozzle when it was too close to the bed, apparently the bristles made contact  with the bed power connector and sparked. Now the screen is blue for a minute when turned on but then goes black. Thoughts on screen fried or mother board?

Comments

  • Samuel PinchesSamuel Pinches Posts: 2,596Administrator
    Hi @JHW ,

    That is unfortunate to hear :dizzy: 

    It's hard to say if its just one or both - perhaps try to connect printer to pronterface and see if you can control it from a PC. The main motherboard is more likely.

    Cheers,
    Sam
Sign In or Register to comment.