Clip being hit by start script when wiping

A newer version of A5 got these 2clips on front and back

when using start script with wipe (partial list below)
  • G1 X60.0 E9.0 F1000.0 ; intro line
  • G1 X100.0 E21.5 F1000.0 ; intro line
will hit the front left clip.

Any workaround for this problem?

Comments

  • rhaub101rhaub101 Posts: 78🌟 Super Member 🌟
    Pull the clip off and move it to the side
  • victagayunvictagayun Posts: 16Member
    thanks!
    I was thinking about that too!
  • Samuel PinchesSamuel Pinches Posts: 2,688Administrator
    edited December 2019
    CAUTION:
    under the bed are white marked zones where it is safe to put the clips. If you put the clips on other areas, the clip can cut through the paint, and then short circuit the entire printer.

    Instead of clips, you can use two long strips of masking tape on each side of the bed to hold it to the heater plate.

    You can also change the gcode to change the position and movements in the start script...
    Post edited by Samuel Pinches on
Sign In or Register to comment.